Portable steel bar cutting machine - Wenzhou steel bar cutting machine manufacturer

There are generally two types of steel bar cutting machines: fully automatic steel bar cutting machines and semi-automatic steel bar cutting machines. The fully automatic steel bar cutting machine, also known as the electric cutting machine, is a machine that converts electrical energy into kinetic energy through a motor to control the cutting edge of the cutting blade and achieve the effect of cutting steel bars. The semi-automatic method involves manually controlling the incision to cut the steel bars. At present, most of them should belong to hydraulic steel bar cutting machines. Hydraulic steel bar cutting machines are divided into two categories: rechargeable and portable. And the working principle of this tool. The portable steel bar cutting machine opens the oil drain valve in a clockwise direction, lifts the pressure rod, lifts the plunger, opens the oil suction valve, and hydraulic oil enters the oil chamber; Lift the pressure rod and the hydraulic oil is compressed into the inner chamber of the cylinder block, thereby pushing the piston forward. The moving cutter installed at the front end of the piston can cut the material. Immediately after cutting off the material, turn the oil valve counterclockwise to open it. Under the action of the reset spring, the pressure oil flows back into the oil chamber, and the cutter automatically retracts into the cylinder.

You should know that the steel bar cutting machines on the market have been perfected and improved over several years, and the equipment we see now can be considered to have relatively complete functions. In addition, the performance and quality of the steel bar cutting machine have also been improved. So, what key points should be grasped when using steel bar cutting equipment?

1. Before using the steel bar cutting machine, relevant personnel must check whether the blade installation of the equipment configuration meets the standard for firmness. In addition, it is also necessary to observe whether the gap is appropriate. Steel bar cutting machine

2. It is also necessary to check the lubrication of the transmission system and moving parts of the equipment for any abnormalities. Before officially putting into production, it is necessary to conduct a no-load trial run for a period of time, and only after confirming that there are no problems can the formal operation begin.

3. The horizontal gap between the fixed blade and the movable blade on the steel bar cutting machine must be maintained within the specified range. In addition, the overlap between the two blades should be determined based on the diameter of the steel bars we need to cut. Different steel bar diameters should be adjusted by increasing or decreasing the spacer blocks behind the fixed blades, in order to adjust the gap between the two blades.

4. When the steel bar cutting machine is in operation, portable steel bar cutting machines should be used, and relevant operators should grip the steel bars that need to be cut tightly with their hands. This avoids accidents of varying degrees. Portable steel bar cutting machine

5. Steel bar diameters exceeding the specified standards for cutting machines, small steel bar cutting machines, or electric steel bar cutting machines that do not meet the specified steel bar composition cannot be operated on the cutting machine.

6. During the operation of the steel bar cutting machine, it is strictly prohibited for workers or other personnel to use their hands to clean the debris and debris on the blades.

7. If the staff detects abnormal sounds or poor blade sealing during the operation of the equipment, they should immediately stop the operation and carry out maintenance and repair. Then wait for the trial run and ensure that there are no issues before continuing with the operation. Steel bar cutting machine

8. Before using the steel bar cutting machine, it is necessary to carefully check the oil level in various parts of the equipment and whether the rotation direction of the motor meets the standards.

9. When the relevant operators carry out maintenance, operation, and cleaning work for the steel bar cutting machine, it is recommended that everyone wear insulated gloves that meet the standards.

Wenzhou Jietuo Electromechanical Co., Ltd. is an enterprise specializing in the production and export of portable hydraulic electric steel bar quick disconnectors, steel bar cutting machines, steel bar bending machines, shear pliers and other tools. Our national consultation hotline is 13819758083. With many years of production experience, we bring you the best steel bar processing machinery products and high-quality services, making you feel at ease when using them.